Tractel volt trac 250 Manual De Empleo Y De Mantenimiento página 17

Do not wrap the load chain around a load.
Do not use the hoist upside down.
Never suspend the hoist by its load chain hook or its
electrical cables.
Never start an operation without ensuring that all the
safety devices on the hoist are in place and operating
correctly. Checks must be made to ensure that the limit
switches are in the required locations to stop the hoist
automatically in total safety.
Never connect the hoist without checking that the main
electrical installation is in accordance with a relevant
safety regulation.
Never drag a load on the floor.
Never force the hoist movements if the load chain
cannot operate freely.
Never mount a load on the dead end chain.
Transport of hot or molten material may require
additional equipment or devices; refer to relevant norm.
Never intentionally cause or leave a suspended load
to swing.
Never remove or modify the hooks latches.
Never remove the electrical limit switches.
Never force the hoist suspension hook or lug to make
hoist rotate on its axis.
Never touch moving parts in operation.
Prohibitions on use
2.
Tearing off loads.
Pulling loads which are tilted.
Removing load under vacuum effect.
Moving load heavier than the W.L.L.
Moving the trolley by pulling the pendant control box or
by the cable of the pendant control.
Carrying people with the hoist is strictly prohibited.
Carrying out maintenance without disconnecting the
hoist from the electrical supply is strictly prohibited.
Carrying out maintenance operation when the hoist is
loaded is strictly prohibited.
Using the ECH or ECHWT with people being under the
load.
Using the ECH or ECHWT when it is under maintenance
operation.
Using the chain of the ECH or ECHWT to sling the
load.
Using the ECH or the ECHWT when the chain is
twisted, kinked, damaged, or worn.
Using the ECH or the ECHWT before reading and
understanding the complete operating instruction
manual
Using the ECH or the ECHWT with higher duty factor
than marked on the hoist specification plate.
Using the ECH or the ECHWT if the regular inspection
has not be done.
Using the ECH or the ECHWT if it is not in accordance
with the national law of the country where it is used.
Using the ECH or the ECHWT if you do not have the
right electric power supply..
Using the ECH or the ECHWT in explosive atmosphere.
Using the ECH or the ECHWT if the electrical protection
is not in accordance with local regulation.
Using the ECH or the ECHWT if the equipment is not
in perfect working condition.
Using the ECH or the ECHWT which has been modified.
To use ECH or ECHWT if the temperature is below -20
degrees Celsius or above +40 degrees Celsius.
GB
17