Replacing A Fuse - Honda HF2317 Manual De Instrucciones

6.4.7 Replacing and repairing tyres
The tyres are of the «Tubeless» type and therefore all puncture re-
pairs will have to be carried out by a tyre-repair expert in accordance
with the methods for this kind of tyre.
6.4.8 Replacing bulbs
HF23•• •• HF2417HB•
◊
The bulbs (10W) have a bayonet fitting and are installed in the
bulb holder which can be taken out by turning it anti-clockwise
with pliers.

6.4.9 Replacing a fuse

The machine is fitted with fuses with different capacities and func-
tions, as indicated in the table below:
1 - 10 Amp - (Red)
HF23•• •• HF2417HM• HF2625HM•
◊
2 - 15 Amp - (Blue)
HF2417HT• HF2625HT•
2 - 15 Amp - (Blue)
3 - 10 Amp - (Red)
– When the fuse (1) trips, the machine stops and the control panel
is completely switched off.
– When fuse (2) trips, it is shown by the battery warning light(
4.13.f).
– When fuse (3) trips, the grass catcher tipping control motor
will not work.
IMPORTANT
A blown fuse must always be replaced by one of
the same type and ampere rating, and never with one of another
rating.
EN 26
:
general and power circuit pro-
tection of the electronic circuit
board;
protection of the charging cir-
cuit;
protection of the charging cir-
cuit;
grass catcher tipping control
circuit.
If you are unable to understand why it has blown , contact your
dealer.
6.4.10 Replacing the belts
Replacing belts is quite a complicated process of dismantling and
subsequent adjustment and must only be carried out by your dealer.
NOTE
Replace the belts as soon as they show obvious
signs of wear! ALWAYS USE GENUINE REPLACEMENT BELTS!