Maintenance; Tip Wear - ASM L1900 Instrucciones

Maintenance

Daily:
Inspect, clean and replace as needed
Manifold filter, gun filter and inlet stainer.
D
Wet cup for leakage, tighten if needed.
D
ASM Packing Seal level.
D
Gun trigger safety.
D
Tip wear, replace if necessary.
D
Electric cord and plug.
D
Weekly:
Check tightness of wet cup.
D
Inspect all high pressure paint hoses.
D
Annually:
Schedule maintenance check at an
D
authorized ASM repair center.
Worn Tips Waste Paint
Cost Money!
SPRAY PATTERN WIDTH
in inches (millimeters)
TIP OPENING ENLARGEMENT
FLOW RATE
in gpm (lpm)
Note: A 515 tip produces a 10 in. pattern width when measured 12 in. from tip to work surface;
spraying paint with viscosity of 20 sec #4 Zahn cup and at 1600 psi (110 bar, 11 MPa).
1. Perform Cleanup, page 47.
2. Wrap cord, place siphon tube set in

Tip Wear

NEW
12
(305) (280)
New Tip Worn to
.015
1/4
(.87) (1.14)
Storage
ti6024b
holder.
11 9
(229)
Worn to
.017 .019
1/3 3/8
(1.4)
WORN
OUT
5.5
(140)
Worn to
.021
1/2
(1.74)
53
309507