Publicidad
Idiomas disponibles
Idiomas disponibles
• Do not wash the internal components of this support surface. Discard the support surface if contamination is found
inside.
• Do not immerse the product in cleaning or disinfectant solutions.
• Do not allow liquid to pool on the product.
• Always inspect support surface covers (top and bottom) for tears, punctures, excessive wear, and misaligned zippers
before each use. If compromised immediately remove the support surface from service.
• Always make sure that you wipe each product with clean water and dry each product after you use cleaning agents.
Some cleaning agents are corrosive in nature and may cause damage to the product. Failure to follow these care and
maintenance instructions may void your warranty.
C C A A U U T T I I O O N N
• Improper usage of the product can cause injury to the patient or operator. Operate the product only as described in this
manual.
• Do not modify the product or any components of the product. Modifying the product can cause unpredictable operation
resulting in injury to patient or operator. Modifying the product also voids its warranty.
• Always be aware of devices or equipment that are placed on the top of the support surface. Damage to the surface may
occur due to the weight of the equipment, heat generated by the equipment, or sharp edges on the equipment.
• Do not put overlays or accessories inside the cover to avoid the risk of reducing pressure redistribution performance.
• Do not allow sharp objects to come into contact with the support surface that could puncture, tear, or cut the cover.
• Do not allow liquid to seep into the zipper area or watershed cover barrier when you clean the underside of the support
surface. Fluids allowed to come in contact with the zipper may leak into the support surface core.
• Do not iron, dry-clean, or tumble dry the support surface covers.
• Do not power wash the support surface as this may damage the product.
• Always dry the support surface covers before you store, add linens, or place a patient on the surface. A dry product
helps to prevent impaired performance.
• Do not over expose the covers to higher concentration chemical solutions as these may degrade the covers.
• Failure to follow manufacturing instructions may also affect useful life of the support surface cover.
2872-009-005 Rev B.1
3
EN
Publicidad
