Additional Accessories; Cleaning - Bosch MS 100 Manual De Instalación Para El Técnico

About the product
Tech data
Permissible ambient
temperature
Protection index
Protection class
Identification number
Ball pressure test
temperature
Degree of pollution
Table 2 Tech data

°C °C
20 14772 44
26 11500 50
32 9043 56
38 7147 62
Table 3 Measurements for cylinder temperature sensor
(TS2...)
 °C 
°C
– 30 364900 25 20000 80
– 20 198400 30 16090 90
– 10 112400 35 12800 95
0 66050 40 10610 100 1344
5 50000 50 7166
10 40030 60 4943
15 32000 70 3478
20 25030 75 2900
Table 4 Collector temperature sensor measurements (TS1)
2.9

Additional accessories

For detailed information about suitable accessories, refer to
the catalogue or Internet page of the manufacturer.
• For solar thermal system 1:
– Solar pump; connection to PS1
– electronically regulated pump (pulse width modulation
or 0-10 V); connection to PS1 and OS1
– Temperature sensor; connection to TS1
– Temperature sensor at the bottom of the first cylinder;
connection to TS2
• Additionally for cylinder 1 external heat exchanger (E):
– Heat exchanger pump; connection to VS1, PS2, PS3
– Temperature sensor on heat exchanger; connection to
TS3
30
0 ... 60 °C
IP 44
I
Data plate ( Fig. 18 at the
end of document)
75 °C
2
 
°C
57301 68 2488
4608 74 2053
3723 80 1704
3932 86 1421
 
°C °C
2492 150 364
1816 160 290
1500 170 233
180 189
110 1009 190 155
120 768 200 127
130 592 – –
140 461 – –
• Additionally for transfer system (I):
– Cylinder transfer pump; connection to VS1, PS2, PS3
• For thermal disinfection (K):
– Thermal disinfection pump; connection to VS1, PS2,
PS3
• Additionally for heat meter (L):
– Temperature sensor in flow to solar collector;
connection to TS3
– Temperature sensor in return from solar collector;
connection to IS1
– Water meter; connection to IS1
For freshwater system:
• Additionally for circulation (A):
– DHW circulation pump; connection to PS1
• Additionally for temperature-dependent return feed (B):
– Valve for return feed; connection to VS1
– Cylinder temperature sensor for changeover
temperature; connection to TS3
• Additionally for preheating system (C, D):
– Cylinder primary pump; connection to PS1
• Additionally for freshwater cascade (E):
– Cascade valves 2 – 4; connection to PS1
Installation of additional accessories
▶ Install the additional accessories in accordance with legal
regulations and the instructions supplied.

2.10 Cleaning

▶ Wipe the enclosure with a damp cloth if necessary. Never
use aggressive or caustic cleaning agents for this.
MS 100 – 6721830547 (2020/12)