Solar Thermal System Configuration - Bosch MS 100 Manual De Instalación Para El Técnico

Commissioning
4.3

Solar thermal system configuration

The configuration of the solar thermal system depends on the
installed control unit. Under certain circumstances only the
basic solar thermal system for solar DHW heating with thermal
disinfection is possible. In this case, the configuration for the
heating system, including the solar thermal system, is
described in the installation instructions for the control unit.
▶ Turn the selector to select the required function.
▶ Press the selector
ok
▶ Press the " key to jump to the system configured at that
point.
▶ To delete a function:
– Turn the selector
(reverse alphabetical order). is displayed.
– Press the selector
– The last function alphabetically is deleted.
Example configuration of solar thermal system 1 with
functions I and K
1. Solar thermal system (1) is preconfigured.
2. Select Transfer system (I) and confirm.
3. Select Therm.dis./daily heat-up (K) and confirm.
As the Therm.dis./daily heat-up (K) function is not always
in the same place in every solar thermal system, this
function is does not appear in the illustration although it has
been added. "K" is added to the name of the solar thermal
system.
36
to confirm the selection.
until the text Delete last function
.
ok
4. To complete the configuration of the solar thermal system,
the system that has been configured up to this point must
be confirmed.
Solar configuration completed...
1.
2.
3.
4.
ok
ok
ok
MS 100 – 6721830547 (2020/12)