Overview Of The Service Menu - Bosch MS 100 Manual De Instalación Para El Técnico

4.4

Overview of the service menu

The menus depend on which control unit and system is
installed.
Service menu
Commissioning
– ...
Solar settings
– Solar thermal sys installed
– Change solar configuration
– Current solar configuration
– Solar parameters
– Solar circuit
– Speed ctrl. solar pump (Solar pump speed control)
– Min. speed solar pump
– Switch-on diff. solar pump (Switch-on temperature
differential of solar pump)
– Switch-off diff. solar pump (Switch-off
temperature differential of solar pump)
– Max. collector temp. (Maximum collector
temperature)
– Min. collector temp. (Minimum collector
temperature)
– Vac. tube pump anti-seize (Vacuum tube pump
curve)
– Southern Europe function
– Switch-on temp. S.Eur. fct. (Switch-on
temperature of Southern Europe function)
– Cylinder
– Max. temp. cyl. 1 (Maximum temperature of
cylinder 1)
– Max. temp. cyl. 3
– Switch-on diff. heat ex. (Switch-on temperature
differential of heat exchanger)
– Switch-off diff. heat ex. (Switch-off temperature
differential of heat exchanger)
– Frost prot. temp. heat ex. (frost threshold
temperature heat exchanger)
– Solar yield/optimisation
– Gross collector area 1
– Type collector array 1
– Climate zone
– Min. DHW temp. (minimum DHW temperature)
– Solar infl. heat. circ. 1 (solar influence heating
circuit 1)
– Reset solar yield
MS 100 – 6721830547 (2020/12)
– Reset solar optimisation
– Set temp. Match-F. (set temperature Match-Flow)
– Glycol content
– Transfer
– Transfer switch-on diff. (transfer switch-on
temperature differential)
– Transfer switch-off diff. (transfer switch-off
temperature differential)
– Solar DHW
– DHW controller act. (active DHW controller)
– Therm.dis./daily ht cyl1 (thermal disinfection/daily
heat-up of cylinder 1 active?)
– Therm.dis./daily ht cyl3
– Daily heat-up time
– Daily heat-up temp.
– Start solar thermal system
2)
DHW settings
– Change DHW configuration
– Current DHW configuration
– DHW parameters
– Max. DHW temp. (maximum DHW temperature)
– DHW
– Circulation time
– DHW circ.pmp op. mode (operating mode of DHW
circulation pump)
– Start frequency DHW circ. (switch-on frequency of
DHW circulation pump)
– Circulation pulse
– Daily heat-up (daily heat-up active?)
– Daily heat-up time (time of daily heat-up)
– Return start temp. (changeover temperature for return
valve)
– Fault display
– Keep hot
Diagnosis
– ...
1) Only available if the MS 100 module is installed in a BUS
system without heat generator (not possible with all control
units).
2) Only available if freshwater system is set (coding switch at
pos. 9)
Commissioning
1)
(time of daily heat-up)
1)
(temperature of daily heat-up)
37