Explanation Of Symbols And Safety Instructions; Explanation Of Symbols; General Safety Instructions - Bosch MS 100 Manual De Instalación Para El Técnico

Ocultar thumbs Ver también para MS 100:
Tabla de contenido

Publicidad

1
Explanation of symbols and safety
instructions
1.1

Explanation of symbols

Warnings
In warnings, signal words at the beginning of a warning are used
to indicate the type and seriousness of the ensuing risk if
measures for minimizing danger are not taken.
The following signal words are defined and can be used in this
document:
DANGER
DANGER indicates that severe or life-threatening personal
injury will occur.
WARNING
WARNING indicates that severe to life-threatening personal
injury may occur.
CAUTION
CAUTION indicates that minor to medium personal injury may
occur.
NOTICE
NOTICE indicates that material damage may occur.
Important information
The info symbol indicates important information where there is
no risk to people or property.
Additional symbols
Symbol Meaning
a step in an action sequence
a reference to a related part in the document
a list entry
a list entry (second level)
Table 1
MS 100 – 6721830547 (2020/12)

Explanation of symbols and safety instructions

1.2

General safety instructions

H Notices for the target group
These installation instructions are
intended for gas, plumbing, heating and
electrical contractors. All instructions
must be observed. Failure to comply
with instructions may result in material
damage and personal injury, including
danger to life.
▶ Read the installation, service and
commissioning instructions (heat
source, heating controller, pumps,
etc.) before installation.
▶ Observe the safety instructions and
warnings.
▶ Follow national and regional
regulations, technical regulations and
guidelines.
▶ Record all work carried out.
H Determined use
▶ Use the product only to control
heating systems.
Any other use is considered
inappropriate. We take no responsibility
for damage caused through incorrect use.
H Installation, commissioning and
maintenance
Installation, commissioning and
maintenance must only be carried out by
a competent person.
▶ Never install the product in wet rooms.
▶ Only use genuine spare parts.
25

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ems 2Ems plus

Tabla de contenido