BULL'S Scorpy Manual De Instrucciones página 14

14/83
2. Setup / Mounting Instructions
Choose a location to hang the dartboard
where there is about 10 feet of open
space in front of the board. The "toe-
line" should be 7' 9 1/4" from the face
of the dartboard. Since this dartboard is
powered with either an AC adapter or
batteries (not included), you could
mount it anywhere or close to an
electronic outlet for convenience.
Remove the batteries when you use an
adapter.
Locate a wall stud and place a mark
60.75" from the floor. Place another
mark 11" directly above the first mark
(75.5" from floor). Center of Bullseye
should be 5' 8" from the floor.
Insert 2 mounting screws in the center
of the stud using the marks you made as
guides. Be sure the top screw is directly
above bottom screw to ensure dartboard
will be level.
Insert 3 "AA" batteries in the battery
compartment on back of dartboard.
Mount the dartboard on the wall by
lining up the holes on the back with the
screws. It may be necessary to adjust the screws until the board fits snugly against the wall
3. Dartboard Functions
POWER button - Press to turn game on or off. Dartboard has an automatic suspend mode to conserve power
and battery life (if using batteries). The dartboard will make sound effect and display "SLEEP" on the display
after approximately 3 minutes of non-use. However, the scores are stored in memory and can be restored by
pressing any button.
PLAYER/PAGE/SCORE button - This button is used at the start of each game to select the number of players
you want to play the game. In addition, this button allows players to see other player scores of not on active
display. This dartboard keeps track of up to 4 player scoring or 4 two-person teams. When playing with more
than 2 players, some scores will be not be visible when not active. This button allows you to page through all
players' scores as needed.
START button - This multi-function button is used to:
- START the game when all options have been selected.
- CHANGE to the next player when one player is finished with his round.
This will put dartboard in HOLD status between rounds to allow player to remove darts from the target area
GAME buttons - Press to page through the on-screen game menu.