Heap Assembled (A = 1), Install - Bosch rexroth 3 842 998 350 Manual De Instrucciones

H3 = 0; T2 = 0; T3 = 0
H3 > 0; T2 > 0; T3 = 0
(Ordering parameters, H3, T2,
T3 according to chapter 6.2,
"Product Description")
A Setting upon delivery.
Minimum working height:
775 mm.
B Minimum working height:
720 mm. The display of
the hand switch shows
the correct working
height.
C Minimum working height
(without table top)
720 mm The display of
the hand switch shows
the correct working
height.
D Minimum working height:
710 mm.

8.4 HEAP assembled (A = 1), install

2x
3 842 528 718
3 842 345 081
1
2
SW13
M = 25 Nm
D
8
3 842 146 815
3 842 526 560
Fig. 16: HEAP, A=1, install (1)
TP = table top
1-4 --> Four different variants available
0 --> Without table top
* Min. working height in lower final position of the modules
Adjust the workstation height using the foot.
„
(In the as-delivered condition, the feet are set to 100 mm in order to be able to
drive under the HEAP with lifting forks).
Anchor the HEAP to the ground, for example, with foundation brackets.
„
If the feet are set to 45 mm when the table top is present and to 85 mm when the
table top is not present, the display of the hand switch shows the correct working
height. Any deviating joint foot settings will result in incorrect display values!
The display of the hand switch shows the working height in cm or inch, see
chapter 9.4.
4×
0,5
B
A
A B
TP = 1-4
C
D
TP = 0
3 842 555 612/2019-01, MPS: HEAP, Bosch Rexroth AG
Assembly 33/78
SW19
M D = 25 Nm
SW17
0,5 A
B
TP = 1-4
TP = 1-4
555 612 -16