Mounting The Table Frame / Initializing The Lifting Modules (Reset) - Bosch rexroth 3 842 998 350 Manual De Instrucciones

38/78 Assembly
Bosch Rexroth AG, MPS: HEAP, 3 842 555 612/2019-01
8.5.2

Mounting the table frame / initializing the lifting modules (RESET)

Fig. 21: Assembly, table frame (1)
Initializing the lifting module (RESET)
During initialization (RESET), the control synchronizes the lift heights of the
connected lift modules.
This procedure is required:
– During the first commissioning of control unit
– When a defective lifting module or control unit has been replaced
– When a warning message is present (A64: forced RESET)
– After power failure during the travel movement
!
RESET
C
B
555 612 -21