General Safety Instructions; Product-Specific Safety Instructions - Bosch rexroth 3 842 998 350 Manual De Instrucciones

2.5 General safety instructions

• As a user, please note the following: Before starting the product for the first time,
carry out a risk assessment according to the Occupational Health and Safety Act
(Germany).
• As distributing company/manufacturer of the machine, observe the following:
Before initial commissioning of a conveyor system, conduct a risk assessment in
accordance with DIN EN ISO 12100.
• Observe applicable accident prevention and environmental protection regulations.
• Observe the safety rules and regulations of the country in which the product is
being used.
• Only use Rexroth products that are in proper working order.
• Heed all the notices on the product.
• People who install/assemble, operate, disassemble or service Rexroth products
must not be under the influence of alcohol, drugs or pharmaceutical medications
that affect their reactions.
• Use only original accessories and spare parts from Rexroth in order to prevent
hazards to people due to unsuitable spare parts.
• Observe the technical data and ambient conditions specified in the product
documentation.
• Only start up the product if it has been determined that the end product (for
example, a machine or system) into which the Rexroth products have been installed
complies with national provisions, safety regulations and application standards.

2.6 Product-specific safety instructions

General
• Never modify or change the design of the product without carrying out another CE
conformity test.
• Do not expose the product to any mechanical loads under any circumstances.
Never use the product as a handhold or step.
• Always ensure that the product cannot topple over.
During transport
• Follow the transport instructions on the packaging.
During installation
• Inspect the product for transport damage. When doing this, pay particular
attention to cables and plugs.
• Do not lift the product by the table top and/or support frame. Do not load the
lifting columns under tension.
• Route the cables and lines adequately protected to prevent mechanical damage
and ensure in this way that no one can trip over them.
• Note the different fields of application for the MPS mains cables.
• Make sure the system component you are working on is depressurized and de-
energized before assembling the product or inserting or removing plugs.
• Ensure that the system component cannot be switched back on.
• Before start-up, make sure that all plug-in connection seals and caps are correctly
installed and undamaged in order to prevent fluids and foreign material from
getting into the product.
Safety instructions
3 842 555 612/2019-01, MPS: HEAP, Bosch Rexroth AG
11/78