Nussbaum SMART LIFT 2.30 SL Manual Del Usuario página 117

Time frame Type of
maintenance
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
OPI_SMART LIFT 2.30 SL-2.35 SL-2.40 SL_V4.4_DE-EN-FR-ES-IT
Maintenance plan
Optical wear measurement:
Catch bar fixation "Safety kit" must be integrated,
!
see Section 9.1.
To check the carrier nut, the cover of the lift spindle must be removed.
There is a carrier nut wear gauge pin integrated into the carrier
plate. This must be flush with the upper edge of the carrier plate (in
the lifting rail, top) - see Figure above.
To a): Changes to manufacturer-specific inspection
1. A wear dimension of 2 mm applies to lifts less than 15 years old.
2. A wear dimension of 1 mm applies to lifts older than 15 years.
Check the position of the capture
hook.
Lower the lift completely. Remove the
cover panels and pull them out up-
wards. Now the position of the cap-
ture hook can be checked through
the holes in the lifting rails. These
must align with the latch.
For platforms above serial number:
379231, the catch can be addition-
ally checked through the holes in the
lifting rails.
a
Pos.
E
Openings in
the lifting rails
117