Nussbaum SMART LIFT 2.30 SL Manual Del Usuario página 93

2 System master sheet
2.1 Manufacturer
Nussbaum Automotive Lifts GmbH
Korker Straße 24
D-77694 Kehl-Bodersweier
2.2 Purpose
The lift is a lifting tool for raising vehicles with a total weight of (* see list) in normal workshop operation at a maximum
load distribution of (2:3**) (1:3***) in or against the drive-in direction A single load from only one or two lifting arms
may not happen.
Set up of the standard lift in explosion and fire endangered workshops and humid spaces
(e.g. washing halls) is prohibited.
Lift operation is done directly on the operating column (see Data sheet).
After construction and maintenance changes on load carrying parts the lift must be inspected afterwards by a specialist
who approves the changes. If the set up location is changed, the lift must be checked again by a specialist and changed
approved.
(*)System load of the SL series (SL = SMART LIFT):
• SMART LIFT 2.30 SL**
• SMART LIFT 2.35 SL**
• SMART LIFT 2.40 SL***
Lifting arm variants
Standard arms
MINI-MAX arms (MM)
DT Lifting arm
Sport Cars Lifting arm
(SC)
OPI_SMART LIFT 2.30 SL-2.35 SL-2.40 SL_V4.4_DE-EN-FR-ES-IT
= 3000 kg
= 3500 kg
= 4000 kg
SMART LIFT 2.30 SL
590 – 900 mm
940 – 1495 mm
600 – 980 mm
1000 – 1480 mm
232SL28000TG
480 – 870 mm
940 – 1495 mm
–
SMART LIFT 2.35 SL
505 – 823 mm
940 – 1495 mm
–
570 – 1160 mm
940 – 1495 mm
590 – 865 mm
840 – 1380 mm
SMART LIFT 2.40 SL
570 – 1160 mm
1130 – 1840 mm
635 – 1065 mm
1130 – 1840 mm
–
–
93