Publicidad
Idiomas disponibles
Idiomas disponibles
4. Installing the product
4.1 Mechanical installation
WARNING
Flying object
Death or serious personal injury
‐
If no pump or coupling is attached to the motor, always remove the parallel key from the motor shaft before starting the motor.
CAUTION
Crushing of feet
Minor or moderate personal injury
‐
Secure the product to a solid foundation by bolts through the holes in the flange or the base plate.
To maintain the UL mark, additional requirements apply to the equipment.
4.1.1 Handling the product
•
Observe local regulations concerning limits for manual lifting or handling. The weight of the product is stated on the nameplate.
CAUTION
Back injury
Minor or moderate personal injury
‐
Use lifting equipment.
CAUTION
Crushing of feet
Minor or moderate personal injury
‐
Wear safety shoes.
‐
Attach lifting equipment to the motor eyebolts.
Do not lift the product by the terminal box.
4.1.2 Cable entries
The cable entries are fitted with blanking plugs from the factory. You can order various cable glands from Grundfos as accessory kits.
Related information
8.5.6 Cable entry sizes
4.1.3 Cooling the motor
•
Install the motor allowing a distance of minimum 50 mm (D) between the end of the fan cover and the wall or another fixed object.
•
Position the product with sufficient space around.
•
Make sure that the temperature of the cooling air does not exceed 50 °C.
•
Keep cooling fins and fan blades clean.
Related information
2.5 Drain holes
4.1.4 Installing the product outdoors or in areas with high humidity
4.1.4 Installing the product outdoors or in areas with high humidity
If you install the product outdoors or in areas with high humidity, take the following action to avoid condensation on the electronic components.
D
11
Publicidad
