Proceed as outlined below.
1)
Loosen the wing nut (A).
2)
Turn the lock lever (B).
3)
Push the share forwards and turn it so it is facing
downwards.
4)
Loosen the nut (C).
5)
Turn the element (D) to position the flexible plate
(E) with the ploughshare (F) as shown in the figure.
6)
Tighten the nut (C).
Adjusting the distance between dual rows and dual row spacing
WARNING
Secure the work vehicle in position (lifted off the
ground) with external means (trestles, etc.).
Do not stand under the hoisted machine unless it is
suitably secured in position.
B
A
UN41-0896UA
Proceed as outlined below.
1)
Raise the machine off the ground just enough to
carry out the operation.
2)
Loosen the nuts (A).
3)
Loosen the screws (B).
4)
Repeat the same operations for the other planting
unit on the same module.
5)
Bring the planting units together to obtain the re-
quired row spacing distance (E).
6)
Tighten the screws (B).
7)
Tighten the nuts (A).
English language
ADJUSTMENT INFORMATION
C
B
A
15
7)
Position the ploughshare (B) as required for the
work to be performed.
8)
Check that the Plant Control device is inside the
share.
9)
Make sure that the share is secured in place with the
lock lever (B).
10) Tighten the wing bolt (A).
Carry out the same procedure to adjust the other plant-
ing units installed.
Adjust the distance between the planting units on the
same module, to obtain the distance required between
the rows.
The distance between the rows depends on the row
spacing range featured (see "Technical characteristics").
Consider installing extensions to obtain the distance re-
quired.
D
8)
Repeat the same operations for the other planting
unit on the same module.
9)
Loosen the screws (C).
10) Place the dispenser unit in the middle of the plant-
ing units.
11) Tighten the screws (C).
12) Adjust the planting modules until the dual row
spacing (F) required is obtained.
Adjust the modules to keep the seedling at a dis-
tance (D) of 10 - 12 cm from the tractor wheel.
5
10 - 12
10 - 12
D
cm
cm
10 - 12
10 - 12
D
cm
cm
E
F
Use and maintenance
D