Publicidad
Idiomas disponibles
Idiomas disponibles
Checking the structure of the three-point hitch
Clean the work vehicle (see "Cleaning the work vehi-
cle").
Visually inspect the three-point hitch structure to check
for structural failures, warping, cracks, etc..
Tyre check
Check the tyres for wear and if they feature tears or signs
of ageing, they must be replaced.
Check tyre pressure and restore if necessary (see "Speci-
Cleaning the work vehicle
Clean the work vehicle with a high-pressure water jet
and, if necessary, with approved detergents.
The liquid used for washing could harm the environment
if it contains pollutants such as detergents, oils, etc.
Troubleshooting
The following list contains a number of common prob-
lems that may arise during work, together with the ways
to solve them.
Problem
The seedling planted is too close to
the surface or too deep
The soil has not been properly com-
pacted on top of the seedlings
The planted seedling is tilted or ly-
ing overturned on the ground
English language
MAINTENANCE INFORMATION
Likely cause
Incorrect planting depth
The dispenser is not synchronised with the
ejector
The packing wheels are not properly ad-
justed
The dispenser is not synchronised with the
ejector
The Plant Control device is not in the right
position
The packing wheels are not set properly
28
If you notice weakening and/or small cracks, contact the
authorised service centre immediately or the manufac-
turer directly.
fications" schedule).
The pressure must be checked with the work vehicle
resting entirely on the ground and with nothing and no-
body on the vehicle (people or things).
Do not dump the waste liquid; dispose of it properly via
authorised disposal facilities with equipment to sepa-
rate pollutants.
Dry with compressed air and lubricate the components
shown (see "Lubrication points diagram").
Make the relative adjustment (see "Planting
depth adjustment")
Adjust the planting unit load (see "Adjusting the
planting unit load")
Adjust the timing (see "Adjusting the dispenc-
ing/ejection timing")
Adjust the packing wheels (see "Adjusting the
spacing between the packing wheels and the
ploughshare")
Adjust the planting unit load (see "Adjusting the
planting unit load")
Adjust the timing (see "Adjusting the dispenc-
ing/ejection timing")
Adjust the Plant Control device (see "Adjusting
the Plant Control")
Adjust the packing wheels
7
Solution
Use and maintenance
Publicidad
