Publicidad
Idiomas disponibles
Idiomas disponibles
G G e e t t t t i i n n g g S S t t a a r r t t e e d d
S S t t a a r r t t i i n n g g t t h h e e S S D D C C 3 3 S S y y s s t t e e m m
1. Press the power button located at the bottom left corner of the front panel to set the power to
O O N N .
2. As the system starts up, the SDC3 shows the welcome screen.
3. The version of the SDC3 software shows under the SDC3 logo.
4. Loading progress shows at the bottom of the screen.
5. To shut down the system, press the power button again.
L L o o g g g g i i n n g g i i n n a a s s a a n n O O p p e e r r a a t t o o r r o o r r A A d d m m i i n n i i s s t t r r a a t t o o r r
If the SDC3 has Access Control enabled, you must log in when the SDC3 starts up.
1. If you have Administrator permission, check the Administrator box.
2. Enter your name in the Operator Name field.
3. Enter the password in password field.
4. Press the L L o o g g i i n n
T T h h e e H H o o m m e e S S c c r r e e e e n n
After the SDC3 starts up, the Home Screen displays. The Home Screen has links to the primary
functions of the SDC3. From the Home Screen, you can:
•
Start a new patient case
•
Access current patient cases
•
Access archived patient information
•
Load patient information into the system
•
Adjust system settings
•
Change surgeon profiles
•
Change operators (if Access Control is enabled)
1. Press the S S E E T T T T I I N N G G S S
2. Press the N N E E W W C C A A S S E E
•
If a patient case has already been started, but there is no data saved to that case, the
system asks, "Do you wish to discard the current case?"
•
If a patient case has already been started, and there is data saved to that case, the system
asks, "Do you wish to create a new case?"
•
Press E E X X I I T T
screen.
EN
14
button. After successful log in, the system shows the Home screen.
button to go to the SDC3 Settings screens.
button to start a new patient case.
to go back to the Home screen. Press O O K K
to go to the New Case
P23566L
Publicidad
