Publicidad
Idiomas disponibles
Idiomas disponibles
P P r r o o b b l l e e m m
No videos written
to the USB
No videos written
to the network
Annotation list is
blank
Device status
overlays do not
appear on the
surgical display
Touchscreen
controls are not
working properly
The SDC3 does
not recognize the
iPad
The SDC3 does
not recognize an
SFB/FireWire
device.
P23566L
S S o o l l u u t t i i o o n n
Make sure "write videos to USB" in the save settings is selected.
Make sure "write videos to Network" in the save settings is selected.
Make sure that a procedure is selected in the Patient information screen
in order to enable the annotation list.
Make sure proper connections have been made between devices and
device ports on the SDC3.
Make sure the device is selected/added in the "Video Settings: On-
Screen Display" menu.
Go to Settings > General. Press the CALIBRATE button to calibrate the
touchscreen.
Unplug the iPad from the USB drive, then plug it back in.
Make sure to wait at least 30 seconds for the iPad to connect.
1. Set the SDC3 power to off.
2. Connect the SFB/FireWire cable to both the device and the SDC3.
3. Set the SDC3 power to on.
85
EN
Publicidad
