Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5. CLEANING AND
MAINTENANCE
W Before cleaning, disconnect the unit
from the power supply.
Do not wash the appliance by pouring
water over it.
Do not use soaps, detergents or
abrasive products to clean the
appliance. After washing, rinse it with
clean water and dry it carefully. When
you have finished cleaning, reconnect
the mains plug to the mains with dry
hands.
• Make sure that no water enters the light
socket or other electrical components.
• The appliance should be cleaned
regularly with a solution of warm water
and sodium bicarbonate. Clean the
accessories separately by hand with
soap and water. Do not wash the
accessories in the dishwasher.
• Clean the condenser with a brush at
least twice a year. This will help you save
on electricity and improve productivity.
The appliance must be
disconnected from the mains
during cleaning work .
DEFROSTING
WATER TRAY
The product has a "no frost" system
designed to prevent ice build-up. Under
normal conditions of use, it should not be
necessary to regularly disconnect the
freezing system.
107 - INOXPAN S.L.
Please note the following: If you regularly
find a large build-up of ice, puddles of
water, in the freezer section, it is likely that
the door is not sealing properly. This could
be due to a faulty door seal.
or an ill-fitting or too heavy decorative door.
For more information
For more information, please refer to the
troubleshooting section on ice-related
problems.
Replacement of LED lights
To replace any of the LEDS, please contact
your nearest Authorised Service Centre.
Note: The quantity and location of the
LED strips may vary depending on the
model.
If the product is equipped with an
LED lamp
This product contains a light source of
energy efficiency class <E>.
If the product is equipped with
LED or LED cards
This product contains a light source of
energy efficiency class <F>.
6. TRANSPORT
AND RELOCATION
The original packaging and the foam can be
retained for re-transporting the appliance
(optional).
• Secure
the
packaging, strong bands or ropes and
follow the transport instructions supplied in
the packaging.
• When relocating or transporting the
appliance, remove all moving parts or
secure them to the appliance by protecting
them with shock protection bands.
The device must always be transported
in an upright position.
appliance
with
thick
Publicidad
