Publicidad
Idiomas disponibles
Idiomas disponibles
EN
If one or more of the LED units of
the device do not work:
• Please contact Customer Service to
arrange a service visit.
Preparation of the installation
This appliance must never be installed near
heat sources, e.g. heating elements or
cookers, or in damp places.
Seek the help of another person, or two,
when installing this appliance. This appliance
may have sharp edges. Use PPE
appropriate for the task and the environment.
• To ensure that the appliance is level,
you should use the height adjustable
feet at the front of the appliance.
• The cooling system at the rear of the
appliance must not touch the rear panel.
The greater the separation, the better.
• The appliance must be installed with
adequate ventilation. Make sure that
there is free space above the appliance
to allow air to escape and that there is
space between the back of the appliance
and the wall.
8. ENERGY SAVING
TIPS
For better energy savings we suggest
:
Install the device away from sources of heat
and out of direct sunlight and out of direct
sunlight.
in a well-ventilated room.
Avoid putting hot food into the refrigerator to
prevent the internal temperature from rising
and therefore continuous operation of the
compressor.
109 - INOXPAN S.L.
Do not overfill food to ensure proper air
circulation.
Defrost the appliance if ice is present to
facilitate the transfer of
cold.
In the absence of electrical power, it is
advisable to keep the refrigerator door
closed.
Open or keep the doors of the appliance as
little as possible.
Avoid adjusting the setting at temperatures
that are too cold.
Remove any dust from the back of the
appliance
Publicidad
