Panasonic GP-UH532C Manual De Instrucciones página 32

y Set brightness detection area [AREA SELECTION]
If bright light such as a spotlight is present in the background behind a subject, the subject may appear dark. To eliminate this
phenomenon, masking bright areas allows users to perform backlight compensation to hide bright areas.
Move the cursor to "AREA SELECTION" and use the [e] or [f] button to select an area.
PF LABEL: •••••••••••••••• ID: PANA_DEFAULT
1
AE * AUTO
SHUTTER AUTO
BINNING OFF
GAIN * AUTO
LONG EXPOSURE OFF
AREA SELECTION ALL
PEAK/AVE LEVEL 8 [ 0 8 ]
*
HEAD GAIN OFF
[ EXPOSURE PICTURE CONTRAST PROFILE FUNC SYSTEM HEAD
The area is selectable from the following:
* The detection areas shown in the drawings below are not displayed.
ALL (default): The detection target is the whole area
on the screen.
S CIRCLE: The detection target is the small circle area
in the center of the screen.
Manually set the detection area
Manually set the detection area.
Detection area setting screen
Step 1
Select "MANU" for "AREA SELECTION", and press the
[SEL] button.
→ The mask setting screen appears.
32
LEVEL 32 [ 0 63 ]
*
---
LEVEL 12 dB [ 3 * 12 ]
---
]
M CIRCLE: The detection target is the medium circle
area in the center of the screen.
L CIRCLE: The detection target is the large circle area
in the center of the screen.
MANU: The detection target is manually specified.
(☞ Page 32)
AUTO: Dark areas are automatically masked, and only
bright areas are detected.
Step 2
Move the cursor to the non-detection area using the [g],
[h], [e] or [f] button and press the [SEL] button.
→ The masked area is displayed in gray.
Note:
• Detection is performed only in the masked areas.
• To cancel a masked area, move the cursor to the area
to be canceled and press the [SEL] button.
To cancel all the masked areas, hold down the [e] and
[f] buttons simultaneously for 1 second or more.
• When "SIMULTANEOUS" or "SIDE-BY-SIDE" is selected
for "3D MODE", "MANU" is disabled.
Step 3
Press the [MENU] button after area setting is complete.
→ The MENU page will be restored.