Panasonic GP-UH532C Manual De Instrucciones página 41

#5 Set HDMI output signal [HDMI1 COLOR DEPTH] [HDMI2 COLOR DEPTH]
Set the output signals for HDMI output connector.
The following is available when 2160p is selected for HDMI output:
YPbPr (420) 8BIT, YPbPr (422) 10BIT
The following is available when 1080p or 1080i is selected for HDMI output:
YPbPr (422), YPbPr (444), RGB (LIMITED), RGB (FULL)
When the setting for HDMI output signal or the video format is changed, the HDMI output video may be interrupted for a few
seconds.
Note:
• When "2160p" is selected for the output of both HDMI1 and HDMI2, "YPbPr(422)10BIT" can be set for the HDMI1 output
signal.
• The HDMI2 video output will be disabled when "YPbPr(422)10BIT" is selected for HDMI1.
#6 Set the synchronizing signal input/output connector
[G/L SYNC TERMINAL SETTING]
Select either "IN" or "OUT (default)".
Important:
• The external synchronization function can be used between this series of control units.
Connect the GP-UH332C or GP-UH532C to the synchronizing signal input/output connector. Then, set "OUT" for the mas-
ter and "IN" for the slave, and apply the same video output format.
#7 Display synchronization state [G/L SYNC STATUS INFO]
The internal synchronization state will be displayed in "INTERNAL".
When "*EXTERNAL" is selected, the horizontal phase can be adjusted.
DISPLAY RANGE(FHD) FULL
OSD POSITION UPPER LEFT
HDMI1 COLOR DEPTH YPbPr ( 420 ) 8 BIT
HDMI2 COLOR DEPTH YPbPr ( 422 )
G/L SYNC TERMINAL SETTING OUT
G / L SYNC STATUS INFO INTERNAL
D MODE OFF
3
* TIME ADJUSTMENT
* USER PROFILE RESET
[ EXPOSURE PICTURE CONTRAST PROFILE FUNC SYSTEM HEAD
Adjust the horizontal phase
Step 1
Move the cursor to "*EXTERNAL" and press the [SEL] but-
ton.
Step 2
Adjust the "H PHASE".
Note:
• The "*EXTERNAL" will be displayed when "IN" is
selected for "G/L SYNC TERMINAL SETTING" and the
external synchronizing signals are input.
In other time, "INTERNAL" is displayed.
• When closing the adjustment screen of "H PHASE"
(horizontal phase in the external synchronization mode),
HDMI video output may be disturbed for approximately
5 seconds.
** SYNC **
H PHASE
RET END
]
.... ....
0
|
+
−
41