Panasonic GP-UH532C Manual De Instrucciones página 6

Specifications concerning safety in medical environment
• The operational mode is "Continuos operation".
• Note that this product is CLASS I rated when using with the AC adapter.
• To avoid danger of electric shock, connect this product only to a power source (commercial) equipped with a protective
grounding.
• Since all peripheral devices connected to the signal input part or the signal output part are constituted as a medical system,
liability and responsibility to make the whole system to fulfill the standards required of IEC60601-1 Clause 16 shall arise.
Do not simultaneously touch any of these connectors and a patient.
• Contact your dealer, installer or customer support described in Operating Instructions for installation.
• Do not install this product in a place where it is difficult to pull out the power cord.
• Use "Hospital Grad" mains plug and POWER SUPPLY CORD for compliant with ANSI/AAMI ES60601-1 (for United States)/
CAN/CSA-C22.2 No.60601-1 (for Canada).
• Under some SINGLE FAULT CONDITIONS, the temperate of right side of the CCU enclosure could get hot and there is a
possible RISK of a burn if touched.
• When this product has been used for many years, there is possibility that some parts may be deteriorated ,that can cause a
malfunction or lead to an accident, depending on the use environment even though there is no defective part in appear-
ance. Check daily if there is any of the following.
Found any of these?
• Smoke, burnt smell or abnormal sound issued.
• The power cord, power plug or AC adapter is
abnormally hot. There is a crack or a breakage.
• Receives a succession of electric shocks when
touching the product.
• No image is displayed when the power is turned on.
• Abnormal sound issued from the fun. Or the fan is
not spinning.
• There is other unusual error or damage.
Descriptions of graphic symbols
This symbol indicates ON/OFF of the power. The ON/OFF state is fixed.
This symbol indicates the equipotential terminal to be used to make each part of the system equipotential.
This symbol indicates an alternating current (AC).
This symbol indicates a direct current (DC).
This symbol indicates a warning symbol could get hot and there is a possible RISK of a burn if touched.
This symbol indicates a UL certification mark in the United States.
This symbol indicates a mandatory conformity marking in the European Economic Ares (EEA).
This symbol indicates a waste electrical and electronic equipment (WEEE) marking in the European
Economic Area (EEA).
6
Stop using this product immediately
To prevent damage of this product or an accident,
turn off the power and ask for inspection or removal of
this product to your dealer or installer.