Panasonic GP-UH532C Manual De Instrucciones página 35

Step 1
Display the color to be adjusted in the screen center as
large as possible.
Step 2
Select the axis close to the target color. The axis is select-
able from the following:
USER (default), B-Mg, Mg, Mg-R, R, R-Ye, Ye, Ye-G, G,
G-Cy, Cy, Cy-B, B
When the color axis is unclear
When "USER AREA" is selected on the "MATRIX" screen, the axis is automatically displayed by selecting a color on the screen.
Color selection is performed on the color detection screen.
The black rectangle cursor is blinking to select a target color on the color detection screen.
Color detection screen
Cy-B
= Cursor (blinking)
Step 1
Point the camera at the center of the subject with which the
color is detected.
If the camera is immovable, move the rectangle cursor to
the area with the target color by pressing the [g], [h], [e]
and [f] buttons.
Note:
• When the blue volume is rotated counterclockwise, the
size of the rectangle cursor changes in the order of
large → medium → small.
Select a size to meet the subject size.
Step 2
Press the [SEL] button or [MENU] button.
→ The "MATRIX" screen appears again.
Press the [SEL] button after selecting the axis.
→ The "MATRIX" screen will be displayed.
To perform fine adjustment, adjust "PHASE" (hue) and
"GAIN" (chroma) with use of the [e] or [f] button.
Select "BEFORE" or "AFTER" with "EFFECT SELECT", and
check if the effect is applied. To determine the setting, select
"SET(NEW SETTING)", and then press the [SEL] button.
To restore the previous setting, select "CANCEL" and then
select the [SEL] button.
<Color matrix splitting chart>
* This chart is a guideline for displaying
the closest axis at adjustment.
To perform fine adjustment, adjust "PHASE" (hue) and
"GAIN" (chroma).
For example, the adjustment of "PHASE" or "GAIN" of "Cy/
Cy-B" on the following screen provides the simultaneous
adjustment of "PHASE" or "GAIN" of the adjacent axes "Cy"
and "Cy-B" in the color matrix splitting chart.
Step 3
Step 4
Step 5
R-Ye
Ye
Ye-G
G
G-Cy
Step 3
** MATRIX ** USER
AFTER ( BEFORE )
B/B-Mg PHASE .... ....
0 ( 0 )
|
.... ....
B PHASE
| 0 ( 0 )
B-Mg PHASE .... ....
0 ( 0 )
|
B/B-Mg GAIN .... ....
0 ( 0 )
|
.... ....
B GAIN 0 ( 0 )
|
B-Mg GAIN .... ....
0 ( 0 )
|
USER AREA *
EFFECT SELECT AFTER
CANCEL SET ( NEW SETTING )
Note:
• When the color on the axis in the color matrix splitting
chart is detected, the adjacent axes are not displayed.
Mg-R
R
Mg
B-Mg
B
Cy-B
Cy
35