KNF Yamato RE212-G Manual De Instrucciones página 100

3. PRE-OPERATION PROCEDURES
Installation Procedure
3. Installing Vapor Tube
(1) Remove joint nut
Press in the lock pin with the thumb to lock
the rotary part. Take off joint nut by turning it
counterclockwise with the other hand.
(2) Install Vapor Tube
Insert Vapor Tube into the Vapor Tube
opening until it clicks, while holding motor
box tightly with the other hand.
(3) Replace joint nut
As with step (1), press in the lock pin to lock
the rotary part. Screw in joint nut clockwise
with the other hand.
(4) Attach flask removal tool
(included with glass set)
① Fit flask removal tool over Vapor Tube.
② Pinch flask removal tool and slip it in joint
nut.
* There is a direction for flask removal tool.
Pawl should come to the joint nut side.
Flask removal tool facilitates removing flask
and Vapor Tube. See "Operation Stop"
(P.28)
Lock pin
Threaded Vapor
Tube opening
①
Lock pin
Flask removal tool
14
Joint nut
Vapor Tube
Joint nut
Joint nut
Pawl
Flask removal tool
DE
EN
FR
ES
IT