KNF Yamato RE212-G Manual De Instrucciones página 109

4. OPERATION PROCEDURES
Rotation Modes
Set rotation direction
F.ro: Forward rotation mode
r.ro: Reverse rotation mode
Ato: Timed auto inversion mode
Default setting is "F.ro"
1. Enter user setting
Fwd R ev
Press 2 sec
2. Change rotation mode
Fwd R ev
①
Fwd R ev
③
3. Exit user setting
Fwd R ev
① Press the Power key.
② Press the
AutoR Sync
② ①
① Turn the
② Press the
AutoR Sync
③ Turn the
②
①
④ Press the
When operating RE unit in reverse position (bath on
AutoR Sync
③
After completing the setting, press the
seconds. Display reverts to previous screen and
shows current rpm.
AutoR Sync
Press 2 sec
Control knob
rpm is on the screen.
Unit enters user setting.
Control knob
RPM display: "rot" flashes
Control knob
RPM display: Current setting flashes
F.ro: Forward rotation mode
r.ro: Reverse rotation mode
Ato: Timed auto inversion mode
Control knob
Control knob
A corresponding lamp among Fwd/Rev/AutoR lamps
illuminates
left), reverse rotation mode can prevent evaporation
flask from scattering bath fluid toward the front by its
rotation.
23
for two seconds while current
and select "rot".
.
to select rotation mode
to finalize.
Control knob
for two