Descargar Imprimir esta página

KNF Yamato RE212-G Manual De Instrucciones página 153

Rotavapor

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 258
4. OPERATION PROCEDURES
Auto-resume Function
Select recovery mode for the event of a power failure.
OFF: Unit goes into idle at power recovery.
ON: Unit automatically reverts to status just before power loss and begin operation once again from
that point.
Default setting is "OFF"
Setting change can be made during standby only.
1 Enter user setting
2 Change the Auto-resume setting
3 Exit use setting
Press 4 sec.
Press 2 sec.
Turn power ON (|) and press
while temperature reading is on the screen.
Unit enters user setting.
1. Select "Pon" using the ∧∨ keys.
Temperature display: "Pon" flashes.
2. Press
key.
Temperature display: Current setting flashes.
3. Use the ∧∨ keys to alter the setting.
4. Press
key to finalize.
Temperature display: New setting is shown for about one
After completion, the screen returns to step 1.
After completing the setting, press and hold
for two seconds. Display reverts to initial screen and
shows temperature reading.
18
key for four seconds
second.
key

Publicidad

loading