KNF Yamato RE212-G Manual De Instrucciones página 112

4. OPERATION PROCEDURES
LED Brightness Setting
Change the LED brightness of the control panel.
The brightness can be set in 8 levels from 0 to 7.
Default setting is "3"
1. Enter user setting
Fwd R ev
Press 2 sec
2. Change LED brightness
Fwd Rev
①
Fwd Rev
③
3. Exit user setting
Fwd Rev
① Turn power ON (|).
② Press the
Unit enters user setting.
AutoR Sync
② ①
① Turn the
② Press the
③ Turn the
AutoR Sync
④ Press the
①
②
AutoR Sync
④
③
After completing the setting, press the
two seconds. Display reverts to previous screen and
shows current rpm.
AutoR Sync
Press 2 sec
for two seconds while current
Control knob
rpm is on the screen.
and select "dSP".
Control knob
RPM display: "dSP" flashes
.
Control knob
RPM display: Current setting flashes
to set desired value.
Control knob
0 (dim) ⇔ 7 (bright)
to finalize.
Control knob
26
for
Control knob
DE
EN
FR
ES
IT