KNF Yamato RE212-G Manual De Instrucciones página 154

4. OPERATION PROCEDURES
Overshoot Alert
When temperature reading goes over "set temperature + alert setting value (°C)", the readout begins
flashing to alert an overshoot.
Alert setting range: 1 to 50°C
Default setting is "50 °C"
Setting change can be made during standby only.
1 Enter user setting
2 Change alert setting value
①
①
③
③
3 Exit use setting
Turn power ON (|) and press
while temperature reading is on the screen.
Unit enters user setting.
Press 4 sec.
1. Select "tAH" using the ∧∨ keys.
Temperature display: "tAH" flashes.
2. Press
② Temperature display: Current set value flashes.
3. Use the ∧∨ keys to alter the setting.
4. Press
Temperature display: Set value is shown for about one
④
After completion, the screen returns to step 1.
After completing the setting, press and hold
for two seconds. Display reverts to initial screen and
shows temperature reading.
Press 2 sec.
key.
key to finalize.
second.
19
key for four seconds
key
DE
EN
FR
ES
IT