Tech-Air 5-systeem Guia Del Usuario página 31

WARNING! Users should be aware that different environmental conditions including
high or low temperatures can influence the characteristics of the protector
and may reduce the performance of the protector, even if the T+ and/or
T- are present in the pictogram.
WARNING! ALWAYS BEFORE ANY USE, CHECK THE BACK PROTECTOR FOR ANY
DAMAGE TO ANY PART OF IT. REGARDLESS OF THE AGE, DO NOT USE THE
SYSTEM IF YOU NOTICE ANY DAMAGE AND/OR DEGRADATION OF THE
BACK PROTECTOR.
The EU Declaration of Conformity of this PPE (as established by the REG. EU 2016/425) can
be downloaded at: eudeclaration.alpinestars.com
The UK Declaration of Conformity of this PPE can be downloaded at:
ukdeclaration.alpinestars.com
Pyrotechnic Articles
The Tech-Air 5 System contains two pyrotechnically activated cold gas inflators, and as
®
such, the whole item is considered as an "AIRBAG MODULE" category P1 under EU Directive
2013/29. As such a EU Type Examination (Module B) has been conducted on the design of
the System, and a EU Type Examination and Audit (Module E) has been conducted on the
assembly of the System.
The EU Type Examination and Audit have been conducted by Notified Body #0080, Ineris,
Parc Technologique ALATA BP2, Verneuil-en-Halatte, 60550, France.
Electromagnetic Stability
The Electronic Unit of the Tech-Air
regulations for electronic and radio devices.
FCC compliance Statement:
The System has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING! Changes or modifications not expressly approved by Alpinestars could
void the user's authority to operate the equipment. (Part. 15.21).
FCC ID: RFR-S50
32 EN
5 System has been tested according to different
®