Adjusting The Blade Guard Guide - Husqvarna WS220 Manual De Instrucciones

Adjusting the blade guard guide

In order for the guide rollers on the blade guard to run
evenly without play , the guide rollers on the blade guard
guide must be adjusted correctly. If the blade does not
center in the blade guard and if there is play on the guide
rollers between the blade guard pipes, they must be
adjusted as follows.
• Insert the blade guard guide between the pipes on the
blade guard.
• Loosen the two hex screws slightly with a 5 mm Allen
key but do not unscrew them completely
• Then turn the two eccentric shafts loosened by the
hex screws with a 22 mm spanner until they are
against the upper pipe on the blade guard.
• Then hold the eccentric shafts with the 22 mm
spanner while tightening the hex screw to lock the
shaft.
24 – English
MAINTENANCE