Machine´s Safety Equipment; General - Husqvarna WS220 Manual De Instrucciones

General

This section describes the machine's safety equipment,
its purpose, and how checks and maintenance should be
carried out to ensure that it operates correctly. See the
"What is what?" section to locate where this equipment is
positioned on your machine.
WARNING! Never use a machine that has
!
faulty safety equipment! Safety
equipment must be inspected and
maintained. See instructions under the
heading Checking, maintaining and
servicing the machine's safety
equipment. If your machine does not
pass all the checks, take it to a service
workshop for repair.
Blade guards
The blade guard must always be used when sawing.
Make sure the blade guard is in working order and that the
outer sections can be locked in place. Also check that the
blade guard guide is adjusted correctly and that the
locking mechanism in the blade guard guide for the saw is
in working order (see the adjusting the blade guard guide
section). Check that the blade is not in contact with the
guard but is centred in the blade guard.
Blade guard lock
Make sure the screw for the blade guard guide is screwed
on when the blade guard is fitted.
MACHINE´S SAFETY EQUIPMENT
End stop on the rail
Make sure that end stops are mounted on the ends of the
rails so that the saw does not come off the rails.
Power pack
Make sure to check the safety equipment on the supplied
power unit. See the power unit manual.
Wall mounting
Place the wall mounts approximately 1/4 of the way in on
the rail. A minimum of two wall mounts must be used while
sawing, if more rails are spliced together, one wall mount
is required for each rail section.
1/4
Track
Make sure the rail joints are assembled correctly and that
the eccentric bolt is tight.
Remote control
The Stop button shuts down the remote control and stops
the saw unit.
OK
ON/OFF
0
–
English 7