Boston Scientific LithoVue Manual Del Usuario página 17

Figure 3�8 – Installing the touch Pc Mounting Plate
8. Tighten the top two M4 x 10 mm Mounting Screws holding the Touch PC to the mounting plate.
9. Install the Power Transformer into the Power Transformer Bracket with the power switch facing
down and hold it in place using the Velcro straps. See Figure 3�10�
10. Attach the AC Power Cord to the Power Transformer. Place the Nylon Cable Clamp (from the Power
Cord Strain Relief Kit) over the AC Power Cord.
11. Mount the Nylon Cable Clamp to the bottom of the Power Transformer Bracket using the #8 flat
washer and 8-32 x 1/4" Phillips-head screw (from the Power Cord Strain Relief Kit).
notE: The loop of the Nylon Cable Clamp should point out the side of the Power Transformer
Bracket. See Figure 3�9�
Figure 3�9 – Installing the Power cord Strain relief Kit
Front
View
12. Organize the Power Cord in the Cord Wrap Hook.
13. Run the DC plug up the outside of the cart post and plug it into the DC power receptacle on the
bottom of the Touch PC.
User's Manual
Inner VESA
Mounting Hole Set
Close-up View Showing
Bottom of Bracket
Power Cord Strain
Relief Kit with
Phillips-head Screw
Power Cord
Strain Relief Kit
17
Black (K) ∆E ≤5.0