Slip-stop function, mechanical
A gentle pull on the cable (no audible click) unlocks the product so the forearm can be moved continuously. When
the pull on the cable stops, the product is locked again.
Slip-stop function, electronic
The slip-stop function is activated by the electrode signals (depending on the chosen control version). When the
electrode signal stops, the product is locked again.
2.2 Combination possibilities
Wrist joints
•
MovoWrist Flex: 10V39=*
•
Ball ratchet wrist joint: 10V8
•
Ottobock wrist joint: 10V18=*
•
Robo-Wrist, mechanical wrist joint: 10V41=*
•
Electric wrist rotator: 10S17 (only for 12K44=* and
12K50=*)
•
MyoRotronic: 12E205 (only for 12K44=* and
12K50=*)
Terminal devices
•
VO hand: 8K22=*
•
VO hand: 8K23=*
•
VC hand: 8K26=*
3 Application
3.1 Indications for use
The product is intended exclusively for upper limb exoprosthetic fittings.
3.2 Conditions of use
The product is designed for use by unilateral or bilateral amputees.
The product is intended exclusively for use on adults.
The product was developed for everyday use and must not be used for unusual activities. These unusual activities
include, for example, extreme sports (free climbing, parachuting, paragliding, etc.).
3.3 Qualification
The fitting of a patient with the product may only be carried out by O&P professionals who have been authorised
with the corresponding Ottobock training.
4 Safety
4.1 Explanation of warning symbols
Warning regarding possible serious risks of accident or injury.
WARNING
Warning regarding possible risks of accident or injury.
CAUTION
Warning regarding possible technical damage.
NOTICE
4.2 Structure of the safety instructions
CAUTION
The heading describes the source and/or the type of hazard
The introduction describes the consequences in case of failure to observe the safety instructions. Consequences
are presented as follows if more than one consequence is possible:
>
E.g.: Consequence 1 in case of failure to observe the hazard
>
E.g.: Consequence 2 in case of failure to observe the hazard
► This symbol identifies activities/actions that must be observed/carried out in order to avert the hazard.
12K41, 12K42, 12K44, 12K50
•
VC hand: 8K27=*
•
Ottobock system hand -passive-: 8K18=*
•
Ottobock system hand -passive-: 8K19=*
•
All-purpose hook: 10A3
•
All-purpose ring: 10A4
•
All-purpose hook: 10A12=*
•
MovoHook 2Grip: 10A71=*
•
MovoHook 2Grip: 10A81=*
•
System Electric Hand: 8E38=* (only for 12K44=*
and 12K50=*)
•
System Electric Greifer: 8E33=* (only for 12K44=*
and 12K50=*)
•
bebionic hand EQD: 8E70=* (only for 12K44=* and
12K50=*)
Application
25