Temperature Safety Information; Setting The Measurement Mode; Temperature Mode Led - Philips SureSigns VS1 PM2200 Instrucciones De Uso

Temperature Safety Information

Temperature Safety Information
Use only
Warning Alaris
Do not use the thermometer if you see any signs of damage to the probe.
When performing defib, sync or electrosurgery, there is a potential for signal corruption.
If a temperature reading is unusually high or low, confirm the reading using another temperature
measuring device before beginning any treatment.
Note— For oral temperature measurements, use the blue probe; for rectal measurements, use the red probe.

Setting the Measurement Mode

The VS1 monitor provides two temperature measurement modes:
• Predictive mode. In Predictive mode, the monitor measures the patient's temperature for
approximately 7 seconds, and then displays the final measurement and sounds a tone signifying
completion.
• Monitoring mode. In Monitoring mode, the monitor measures the patient's temperature
continuously and displays the temperature constantly in large, green numbers (as long as the probe is
in contact with the patient).
You can change the mode in the Measurement Mode screen.
MEASUREMENT MODE: PREDICTIVE
To open the Measurement Mode screen and change the temperature mode:
Step Action
1 From the Line List display, press the System soft key. The System Settings screen appears.
2 In the System Settings screen, press the Temp Option soft key. The Measurement Mode screen appears.
3 Use the Up or Down button to select Predictive or Monitoring mode.
To save your changes, press either the System Screen soft key or the Save → Main soft key. If you press
4
the System Screen soft key, the settings are saved and the System Settings screen appears. If you press the
Save → Main soft key, the settings are saved and the Line List display appears.

Temperature Mode LED

To determine which mode is active, look at the Temperature Mode Indicator LED (the letter M) on the
front of the monitor. If the indicator is lit, Monitoring mode is selected; if the indicator is not lit, Predictive
mode is selected.
6-2
Monitoring Temperature
® ®
probes with your monitor.
Turbo*Temp
SYSTEM
SCREEN
11:06
SAVE
->MAIN