Setting Patient-Specific Alarm Limits; Changing Audible Alarm Settings - Philips SureSigns VS1 PM2200 Instrucciones De Uso

Setting Patient-Specific Alarm Limits

The Auto Update feature allows you to set alarm limits that are based on an individual patient's vital signs
measurements. After you take an initial measurement, you can select the Auto Update soft key to adjust the
alarm limits by a specified percentage of the patient's current vital signs measurements. These percentages
are defined in the Alarm Tolerance screen, as seen in the following illustration.
High+%
Low -%
11:06
PREV.
SCREEN
For example, if a patient's baseline Systolic measurement is 120 mmHg (15.9 kPa), and you want an alarm
to sound if the Systolic value increases by more than 20%, you can specify the 20% alarm tolerance in the
Alarm Tolerance screen. You then press the Auto Update soft key in the Alarms screen, and if the patient's
Systolic value exceeds the 20% tolerance (144 mmHg or 19.1 kPa), an alarm will sound.
When you begin measurements on the next patient, you can use the same percentages specified in the
Alarm Tolerance screen or you can modify them.
If you do not use the Auto Update feature, the monitor uses the alarm limit values in the Alarms screen.
To use the Auto Update feature:.
Step Action
1 Begin measurements on a new patient or open an existing patient ID and begin measurements.
2 When the measurements are complete, press the Alarms soft key. The Alarms screen appears, displaying
the current high and low alarm limit values.
3 Press the Change Tol. soft key to review the current alarm tolerances. Change any alarm tolerance values
you want to change and press the Save → Main soft key.
4 Press the Alarms soft key to open the Alarms screen, press the Auto Update soft key, and then press the
Save → Main soft key.
The screen displays the new alarm limits, which are based on the percentages specified in the Alarm
Tolerance screen. The new alarm limits are activated for the next measurement.

Changing Audible Alarm Settings

The audible alarm is a high-pitched tone that sounds at one-second intervals until a new measurement is
taken and the new measurement falls within the alarm limits.
If, for any reason, the monitor is unable to determine the final blood pressure values during a measurement
cycle, a caution code appears in the LCD and the unit beeps two times to announce a new measurement
cycle is about to begin.
Sys/Dia MAP
50/50 50
20/20 20
SpO
2
50 50
20 20
Setting Patient-Specific Alarm Limits
Temp.
OFF
SAVE
->MAIN
Setting Alarms
8-3