Selecting An Examination - Myray hyperion X5 Manual De Operador

5.2.2. SELECTING AN EXAMINATION

Only for 2D machines
Only for 3D machines
Every screen features an upper tool bar; it is structured as shown in the figure on the left.
1- button.
Connection
Press this button to connect / disconnect the
turns off when the device is in "Demo" mode or there is no
2- Button to display the
off, until the next scan).
3- Button to access the application
selected; the
4- Type of exam
for visualisation status.
5- Status icons of hyperion X5.
28
device.
last
image downloaded on your iPad
settings.
parameters (kV, mA and
OPERATOR'S MANUAL
Once the configuration is completed, the application can be
started by using the relevant icon in the application list.
From now on, every choice made on the console is sent
directly to hyperion X5 and displayed on the control panel.
The application is divided into two main screens: home, 2D
examination selection and 3D examination selection
(only for 3D machines) that can be accessed by pressing
the relevant button on the button bar placed at the bottom
of the screen.
The images on the left show the button bars in case of 2D
version (top) and 3D version (bottom) of the machine.
By way of example, the images used in the following pages
will show the button bar of the 3D version. Unless otherwise
specified, the console functionality in case of 2D version of
the machine is completely
During the connection procedure, this button flashes, and it
connection.
(always saved,
even after the tablet has been turned
are displayed only when the machine is in the "Ready"
SEC)
The main screen (Home) lists the last 3 examinations.
This helps in the quick selection of the scanning protocol.
equivalent.
EN