Inspection And Maintenance; User Inspection - Myray hyperion X5 Manual De Operador

12. INSPECTION AND MAINTENANCE

12.1. USER INSPECTION

These instructions describe the maintenance procedures for the extraoral X-ray system.
These instructions apply to all the revisions of said equipment, as well as all the accessories that may have been provided, therefore the description of some parts may not correspond to your equipment.
Inspection and preventive maintenance must be performed at scheduled intervals to protect the health and safety of patients, users and other persons in accordance with national regulations regarding the use, maintenance of dental x-ray devices
that are in force in the country where the device is installed.
In order to ensure the operational safety and functional reliability of your product, the system owner should check the equipment at regular intervals (at least once a year) or commission an authorized technician to do so.
If one or more checks to be performed are not satisfactory, please contact your dealer tech support.
Step
Check that all labels located
- on side of the device
1 - at the base of the column,
- on the X-ray tube housing,
are intact, well attached and legible.
Check there are no external damages to the equipment which could reduce protection
2
against radiation.
3 Check the remote emission button cable is not broken or scratched.
Check the power switch verifying that the switch is working properly and the green light
4
on the switch, check if the keyboard illuminates when the switch is in the on position.
5 Verify that exposure is immediately interrupted when X-rays button is released
6 Check the control keyboard functionality: functions must respond to interrogation.
7 Check proper functioning of X-ray exposure LED and exposure buzzer
8 Check proper functioning of patient centering laser traces
Perform a motors movement test running the Dummy panoramic procedure, making sure
9 the axis movement (rotation and translation simultaneously) is smoothly and without
noise. See figure 1, next page.
Perform column movements, up and down on the Z axis and check proper functioning.
10
See figure 2, next page.
Check the emergency button functionality. Emergency button is used to stop X-ray
11
device operation, it's located near main switch button.
Check the X-Ray Generator functionality performing a complete trial exam exposure.
Select any panoramic exam and reset the unit. Hold down the emission button
12
throughout the entire exam procedure. Absence of error messages assures a proper
generator functionality.
If Quality Phantoms are not available at installation site, then contact your dealer tech support to have the Quality Assurance procedure performed at your premises
Perform an exam on the 2D Quality Phantom and evaluate the quality of the outcome
13
radiographic image.
Only for 3D machines
( ) Perform an exam on the 3D Quality Phantom and evaluate the
14
quality of the outcome radiographic image
The undersigned confirms that the equipment was checked for the above criteria and that, in case of any malfunction, an authorised technician of the local dealer was informed.
All inspection and maintenance work performed by the system owner and/or service engineer must be recorded in this document and kept near the unit!
64
OPERATOR'S MANUAL
Description
Section Identification label position
Section Description of the operation
Section X-ray emission remote control
Section Turning on the system
Section X-ray emission remote control
Section Console onboard the machine
Section X-ray emission remote control
Section Laser positioning system
Section Perform a simulation (Dummy Run)
Section Console onboard the machine?
Section Emergency stop button
Section Performing a 2D X-Ray examination
Acquisition Operations with Annex
Acquisition Operations with Annex
Reference in User Manual
Operator Name
Signature
EN
Answer questions with yes (√) or no (−)
Inspection DATE
__/__/20__ __/__/20__ __/__/20__ __/__/20__ __/__/20__