Mettler Toledo IND560x Manual De Instalación página 51

3.2.2.2. Wall Mounting
An optional wall mounting bracket kit is available, permitting the IND560x harsh enclosure to be
mounted to a vertical surface. Mount the wall brackets and terminal securely, to prevent the terminal
from falling.
To wall mount the enclosure, follow these steps:
1. Bolt the two brackets to the bottom of the enclosure using the four M5 screws included with the
2. If the enclosure will be mounted above eye level, skip step 3 and proceed to step 4.
3. If the enclosure will be mounted at or below eye level, it will be necessary to reverse the front
64061929 | 11 | 07/2017
brackets. The brackets should be attached as shown in Figure 3-10.
Figure 3-10: Wall-Mounting Brackets (left), Attached to Enclosure (right)
cover 180 degrees. To reverse the front cover, perform the following steps:
A. Open the enclosure per the instructions provided in the Opening the Enclosures section.
Figure 3-9: Rubber Feet, Installed
METTLER TOLEDO IND560x Installation Manual 3-7