Mounting The Terminal; Panel-Mount Enclosure - Mettler Toledo IND560x Manual De Instalación

3. Set the screws aside for reassembly later.
4. Hold the front cover and the enclosure together as you flip the enclosure back over to its normal
5. Remove the cover. The cover will swing down, hinged by two wire cables at the bottom.
3.2.

Mounting the Terminal

The panel-mount enclosure is designed to mount into a cutout of a flat surface such as an
instrument panel or industrial enclosure. The harsh enclosure is designed to be placed on a
desktop or can be mounted to a vertical surface or column using various optional mounting
brackets. Mount the terminal where viewing is optimal and the terminal keypad is easily accessible.
Observe location and environment considerations as described in Chapter 1, Introduction.
3.2.1.

Panel-Mount Enclosure

The panel-mount enclosure includes aluminum clamping brackets at the side of the extrusion. Two
Allen-head set screws are used to tighten each bracket against the panel surface. The enclosure will
mount and seal properly on panel thicknesses from 16 GA to 11 GA. A panel-stiffener bracket is
available as an option for applications where extra support is required.
Install the panel-mount enclosure by following these steps:
1. Loosen and remove the four Allen-head screws that secure the clamping brackets to the side of
64061929 | 11 | 07/2017
position.
the housing (see Figure 3-4). Use the 2mm Allen wrench included with the terminal.
Figure 3-3: Front Panel Screws
METTLER TOLEDO IND560x Installation Manual 3-3