Wiring Connections For Acm500 Options - Mettler Toledo IND560x Manual De Instalación

Ocultar thumbs Ver también para IND560x:

Tabla de contenido

Idiomas disponibles

4. When installing a fiber optic cable, the connectors on the end of the cable will snap into the

5. On the harsh enclosure terminal, after all fiber optic cables have been connected, tighten the

Wiring Connections for ACM500 Options

Options available for the IND560x terminal that are installed inside the ACM500 module in the safe

area and require external connections include the following:

METTLER TOLEDO IND560x Installation Manual

transmitter or receiver on the interface board. Grasp the connector only (not the cable) when

inserting or removing. Only gentle pressure is required.

Some typical wiring schemes are listed in Table 3-17, Table 3-18, and Table 3-19. Note that

the "U" number listed in the tables below is the transmitter or receiver on the fiber optic interface

option. The transmitter is gray in color and the receiver is blue in color.

Table 3-17: FO Cables to ACM500 Accessory

Table 3-18: FO Cables to Dual Channel FO Converter Accessory

Table 3-19: FO Cables to IND560x Remote Display

compression nuts on the outside of the harsh enclosure cable glands to secure the fiber optic

Fiber Optic Interface

I.S. Current Loop Interface

Ethernet/COM2/COM3

Analog Output

Allen-Bradley RIO

Dual Channel

FO Converter

Dual Channel

FO Converter

Tabla de contenido