Ultra Ata66 Cable/Drive - Sonnet Tempo Ultra ATA66 Manual De Instalación

En
Ultra ATA66 Cable/Drive Configurations
The Tempo Ultra ATA66 allows the connection of
up to four internal IDE hard drives (cable for two
drives included); for example, two master and two
slave hard drives. Regardless of the number of drives,
the master drive, or in the case of one drive, must
always be installed on the end of the Ultra ATA66
cable for proper termination. If a slave drive is
installed, it should be connected on the intermedi-
ate connector on the cable.
Figures 2 and 3 illustrate the possible drive con-
nection configurations available with the Tempo
Ultra ATA66 and one Ultra ATA66 cable.
Support Note:
(one with data on it already) is connected
to the Tempo Ultra ATA66, you must initialize the
drive for your system to recognize it. Since all data
will be erased, make a backup if necessary prior to
connecting the drive to the Tempo.
When an existing drive
Tempo Ultra ATA66 Macintosh
PCI Host Adapter
Ultra ATA66 cable (included)
drive 0
(single or master)
Figure 2; Figura 2
Tempo Ultra ATA66 Macintosh
PCI Host Adapter
Ultra ATA66 cable (included)
drive 1
(slave)
drive 0
(master)
Figure 3; Figura 3
1-3