Sonnet Tempo Ultra ATA66 Manual De Instalación página 53

En
5. The current internal hard drive's power cable
should have an additional drive power
connector. Thread the power connector along
with the Ultra ATA66 cable through the
opening of the drive bay (Figure 7).
6. Work the power connector along with the
Ultra ATA66 cable into the expansion bay
(Figure 8).
7. Attach the power connector and the master
connector on the Ultra ATA66 cable to the
hard drive (Figure 9); if you are unfamiliar
with the Ultra ATA66 cable connectors, see
page 1-2, Figure 1 for further information.
8. Slide the hard drive into the expansion bay
(Figure 10).
Close Computer
1. Carefully position the Ultra ATA66 cable inside
the computer to avoid crimping it by the case
cover and replace the side panel onto your
Power Macintosh.
2. Return the computer to your computing area
and reconnect the power and peripheral cables
to the computer.
Turn On Computer
1. Turn on your Power Macintosh.
2. For your computer to properly recognize a
new hard drive, you will need to initialize
and format it. Refer to Chapter 6, "Hard
Drive Initializing" for further instructions.
Ultra ATA66 cable
additional power
connector
Tempo
Figure 7; Figura 7
drive power
connector
Figure 8; Figura 8
drive power
connector
Figure 9; Figura 9
hard drive
Figure 10; Figura 10
opening in
drive bay
Ultra ATA66 cable
Ultra ATA66 cable
4-4