Sonnet Tempo Ultra ATA66 Manual De Instalación página 35

En
5. Configure the hard drive with appropriate
jumper settings. If necessary, use a small flat
blade screwdriver or needle nose pliers to
set the jumpers. (For further information, see
Chapter 1, "Configuring and Connecting Your
Hard Drive.")
6. Attach the master connector of the Ultra
ATA66 cable to the hard drive. (See page 1-2,
Figure 1, for further information.)
7. Depending on your computer model,
mount the hard drive to a drive mounting
bracket/carrier (Figure 1) or a drive sled
(Figure 2). You will require a medium
Phillips screwdriver and hard drive mounting
screws to perform the installation. If necessary,
refer to your computer's user guide for specific
information on the installation of internal
storage devices.
8. Install the hard drive into an expansion bay.
9. Attach a power cable connector to the hard
drive (there should be an additional
connector on the existing internal hard
drive's power cable).
10. Locate an available PCI slot and remove
its access port cover (if present).
drive mounting
bracket/carrier
Figure 1; Figura 1
drive sled
Figure 2; Figura 2
2-3