Sonnet Tempo Ultra ATA66 Manual De Instalación página 49

En
Shut Down and Open Computer
1. Shut down your Power Macintosh.
2. Disconnect the power and peripheral cables
from the back of the computer and move it to
an area where you can freely work.
3. With the front of the computer facing you,
open your Power Macintosh by removing
the side panel. Depress the green button and
lower the panel away from the computer's case
(Figure 1).
Support Note:
(one with data on it already) is connected
to the Tempo Ultra ATA66, you must initialize the
drive for your system to recognize it. Since all data
will be erased, make a backup if necessary prior to
connecting the drive to the Tempo.
Install the Hard Drive
1. Determine the expansion bay where you will
install the hard drive and remove the front
bezel piece. In Figure 2, the lower drive
expansion bezel has been removed.
2. Slide the hard drive mounting bracket forward
and out of the expansion bay (Figure 2).
You may need to pull firmly on the bracket.
When an existing drive
Figure 1; Figura 1
drive mounting
bracket
drive bay bezel
Figure 2; Figura 2
4-2