Sonnet Tempo Ultra ATA66 Manual De Instalación página 63

En
Install Tempo Ultra ATA66
1. Select an available PCI slot to install the Tempo
and remove its access port cover (Figure 10).
2. Remove the Tempo from the anti-static
package, making sure to handle the board by
the edges.
3. Align the Tempo over the PCI slot
(Figure 11). Gently press down until it is
firmly seated in the PCI slot, taking care not
to wiggle the board as you install it into
the slot.
4. Attach the host connector on the Ultra ATA66
cable to the connector closest to the bracket on
the Tempo (Figure 12); if you are unfamiliar
with the Ultra ATA66 cable connectors, see
page 1-2, Figure 1, for further information.
Close Computer
1. Carefully position the Ultra ATA66 cable inside
the computer as to avoid crimping it by the
case cover and replace the side panel onto
your Power Macintosh.
2. Return the computer to your computing area
and reconnect the power and peripheral cables
to the computer.
Turn On Computer
1. Turn on your Power Macintosh.
2. For your computer to properly recognize a
new hard drive, you will need to initialize
and format it. Refer to Chapter 6, "Hard
Drive Initializing" for further instructions.
access port cover
Figure 10; Figura 10
Tempo
Figure 11; Figura 11
Ultra ATA66 cable
Figure 12; Figura 12
5-5