Shut Down And Open Computer; Install The Hard Drive - Sonnet Tempo Ultra ATA66 Manual De Instalación

En

Shut Down and Open Computer

1. Shut down your Power Macintosh.
2. Disconnect the power and peripheral cables
from the back of the computer and move it to
an area where you can freely work.
3. With the front of the computer facing you,
remove the case cover from your Power
Macintosh. Locate the two switches on the
underside of the front cover, depress them,
and slide the cover forward and off the
computer (Figure 1).
Support Note:
(one with data on it already) is connected
to the Tempo Ultra ATA66, you must initialize the
drive for your system to recognize it. Since all data
will be erased, make a backup if necessary prior to
connecting the drive to the Tempo.

Install the Hard Drive

1. Identify the internal components of your
computer. Touch the power supply metal
shielding (Figure 2) to discharge potential
damaging static electricity, and rotate the
expansion card cover up and to the left
(Figure 2).
2. Determine the expansion bay where you will
install the hard drive. For the purposes of these
instructions, the hard drive will be installed
into the lower expansion bay (Figure 3).
When an existing drive
Figure 1; Figura 1
power supply
metal shielding
expansion card cover
Figure 2; Figura 2
expansion bay
drive bay bezel
Figure 3; Figura 3
3-2