Sonnet Tempo Ultra ATA66 Manual De Instalación página 61

En
Support Note:
(one with data on it already) is connected
to the Tempo Ultra ATA66, you must initialize the
drive for your system to recognize it. Since all data
will be erased, make a backup if necessary prior to
connecting the drive to the Tempo.
Install the Hard Drive
1. Using a small flat blade screwdriver or needle
nose pliers, properly configure the hard drive's
jumpers. For further information on jumper
settings, see Chapter 1, "Configuring and
Connecting Your Hard Drive."
2. Depending on your computer model, mount
the new drive to either the single drive carrier
or drive sled with appropriate screws. Attach
the master connector on the Ultra ATA66 cable
to the hard drive; if you are unfamiliar with the
Ultra ATA66 cable connectors, see page 1-2,
Figure 1, for further information. Figure 8
illustrates a new drive with attached Ultra
ATA66 cable mounted onto a drive sled.
3. Reinstall the drive carrier or drive sled into the
computer and attach a drive power connector
to the new drive; the internal hard drive's
power cable should have an additional power
connector. (This power connector may be
tucked behind the power supply bracket.) If
disconnected earlier, reconnect the logic board
power bundle, hard drive ribbon cable and
hard drive power cable to the logic board. Your
system should appear similar to what is shown
in Figure 9 after everything is reinstalled and
reconnected.
When an existing drive
Figure 8; Figura 8
new IDE
hard drive
power cord
bundle
Figure 9; Figura 9
internal
hard drive
hard drive
ribbon cable
5-4