Tabla de contenido
Publicidad
AMPROBE
F3, F4:
to move the cursor of the selected harmonic leftwards and rightwards
respectively. At the same time the values relevant to the order no. of
the selected harmonic and to the corresponding absolute and relative
values (calculated on the basis of the fundamental) are updated.
to display the page of the harmonics h01 ÷ h24 (h24 symbol) or that
F2:
of the harmonics h25 ÷ h49 (h49 symbol).
ESC:
to return back to METER mode (see paragraph 8.5.2)
SAVE:
to store in the instrument memory a record of "Smp" type (see
paragraph 9.2) and the instantaneous values of voltage and current
present on the instrument inputs. This function is disabled during a
recording.
ENTER/HOLD: to enable/disable the HOLD function (updating interruption) of the
displayed data. All the previous functions remain however available.
When the HOLD function is enabled, the word
When this function is enabled it's not possible to record or take an
energy measurement. This function is disabled during a recording or
an energy measurement.
MENU:
to enter in the MENU mode and change the instrument settings (see
paragraph 8.1 and 8.2). It's not possible to enter the configuration
MENU during a recording or an energy measurement.
START/STOP:
to record selected parameters according to the instrument's settings
(see chapter 10).
MULTITEST2000
HOLD
is displayed.
Publicidad
Capítulos
Tabla de contenido
